How to Repair Garage Door Springs and Cables

How to Repair Garage Door Springs and Cables

If you need to repair garage door springs and cables, you need a professional to take care of it. There are easy to follow instructions on repairing garage door springs.

How will I repair my garage door springs?

The list of helpful tools and materials you will need to repair your garage door should be reviewed before starting.

  • Hammer
  • Clamps
  • Leather gloves and safety goggles are included.
  • Hammer
  • Wrench set with an adjustable wrench
  • Drill
  • Locking pliers
  • Winding bars
  • Ratchet and socket set
  • Lift cables
  • Torsion springs
  • Bottom brackets

There are some steps to follow in repairing a garage door.

Lock the garage door and loosen the springs.

We’ll go over each of these.

Lock the garage door and loosen the springs.

The garage door can be locked using the locking pliers and clamps. There is a chance of an accident if the garage door is unlocked.

You can loosen the spring using your winding bar. Put it into the winding cone roll up doors repair and loosen the set screws. The spring can change direction when loosened.

The springs are in the center of the picture.

Place the second winding bar into the next hole and it will make a 90-degree angle between the winding bars. After that, turn the spring. This is done in motion.

The bolts and nuts are in the cones. Try to get the springs to go to the brackets.

The third step is to remove the springs.

The set screws on the right and left light cable need to be loosened. Remove the cables.

If you want to start on the left side of the door, you have to slide the tube to the right. You can remove the drum if you do that. The spring can be pushed off the tube.

New center bearing and left spring are needed.

You need to replace the spring by sliding it onto the tube. You will need to have the stationary cone facing the center brackets during this part. You will be able to put the cable drum back in after that.

You need to slide the center bearing onto the bar to connect the cones.

It’s the perfect time to change cables and rollers. The lift cable loop can be placed on the new bottom brackets.

Step #6: Thread Cables and Tighten Drums

You need to put the lift cable on the cable slot. The drums should be tightened by using the pliers. After that, it is time to tighten the wire as much as possible.

You want to make sure that both sides of the garage door are locked. The door will open evenly.

In most cases you will be able to apply these easy to follow instructions and repair your springs and cables, however if the task is more than you would like to do, call our professionals at Garage Service Pros.


Leave a Reply

Your email address will not be published.